FEATURES
- Use with 3M Twist ‘n Fill chemical management system
- Uses effervescing action to clean carpet and non-porous surfaces
- Low odor
- No rinsing is required
- Designed to be used with cold water
- Green Seal GS-37 Certification
- High flow for use in filling buckets
- 2 liter concentrate bottle yields 53 ready-to-use gallons
GENERAL USE DIRECTIONS
Dilute 3M 34H Peroxide Cleaner Concentrate using the Twist ‘n Fill dispenser into a properly labeled sprayer, bucket, autoscrubber, or extractor.
- Dispense with cold water using the Twist N Fill dispenser into a properly labeled container.
- Apply the solution using a mop and bucket.
- Scrub as required using a hand pad or sponge and wipe the surface dry.
- When used on carpet or upholstery, blot to remove spot or stain and rinse with water.
- Floors may be slippery when wet.
- Dispense with cold water using the Twist N Fill dispenser into a properly labeled container.
- Apply the solution using a mop and bucket or autoscrubber.
- Thoroughly wet floor with solution.
- Let solution stand for several minutes to penetrate soil and soap scum.
- Agitate using a brush or floor pad.
- Pick up soiled solution using a mop or wet vacuum.
- Rinse with clean water.
- Dispense with cold water using the Twist N Fill dispenser into a properly labeled container.
- Vacuum the carpet area thoroughly.
- Place the extraction cleaner solution directly into the solution tank of your carpet extractor or tank of your sprayer.
- Extract the carpet using overlapping passes of the extraction wand.
- Move the extractor slowly over the carpet, making two passes.
- 1st pass: dispense the peroxide cleaner throughout
- 2nd pass: vacuum only – do not reapply solution
- Dispense with cold water using the Twist N Fill dispenser into a properly labeled container.
- Vacuum the carpet area thoroughly.
- Fill the extractor with cold water only.
- Apply the peroxide cleaner to the carpet area using a sprayer at a rate of ~50 ft per diluted gallon.
- Allow 1-3 minutes of dwell time.
- Provide agitation to heavily soiled areas using a brush or carpet bonnet (optional).
- Extract the carpet using overlapping passes of the extraction wand.
- Move the extractor slowly over the carpet, making two passes.
- 1st pass: dispense rinse water throughout
- 2nd pass: vacuum only – do not apply additional water
Reviews
There are no reviews yet.